Warner Electric ZRC Clutch_ARC Top Load User Manual
Page 12
12 Warner Electric • 800-825-9050
P-2018 • ZRC/ARC
Tighten using spanner wrenches (YTL3-0009) and a
soft hammer. See Figure 62.
Figure 57
Install shaft in top load assembly. Make sure all 4
pins stay engaged during insertion. See Figure 58.
Figure 53
Set top-load on FIX-0002 so that the shaft does not
push in while compressing the spring. Install lower
spring cover (if applicable), spring, upper spring
cover (if applicable), and spring plate. See Figure 59.
Figure 54
Compress spring plate and install snap ring. Make
sure that the snap ring seats fully into groove. See
Figure 60.
Figure 55
Thread together the clutch and top-load assembly.
See Figure 61.
Figure 56
Install set screw with 1/8” 3mm hex wrench; tighten.
Tighten set screws to 8-10 lb-in. Over tightening is
not necessary and will strip the screws or possibly
damage the housing body. See Figure 63.
Figure 58