Warner Electric ZRC Clutch_ARC Top Load - Manual (Page 8)

8 Warner Electric • 800-825-9050 P-2018 • ZRC/ARC
Press Shaft out of unit. Separate remaining
components. Clean or replace all parts as required.
Use an alcohol based cleaning solvent to clean the
black driver magnets. Do not use anything abrasive
when wiping the black driver magnets. Use a Scotch
Brite deburr wheel to polish the hysteresis magnet.
See FIgure 28.
Figure 28
Using an arbor press and FIX-0001 push out
bearings in adjustable end cap and housing. See
Figure 30.
Figure 30
FIX-0001
Using an arbor press and FIX-0001 install new
bearings in adjustable end cap and housing. See
Figure 31.
Figure 31
FIX-0001
Using a 9/64” (M3) hex wrench, remove the socket
head cap screws. See Figure 29.
Figure 29
Replace all seals and apply a light layer of grease on
seals. See Figure 33.
Figure 33
Using a 9/64” 3mm hex wrench, install magnet plate
assembly on adjustable end cap. See Figure 32.
Figure 32