Warner Electric ZRC Clutch_ARC Top Load - Manual (Page 9)

Warner Electric • 800-825-9050 P-2018 • ZRC/ARC 9
Install shaft into adjustable end cap magnet
assembly. Apply a light film of grease on magnet.
See Figure 34.
Figure 34
Install spacer on shaft on end cap. See Figure 35.
Figure 35
Install Hysteresis magnet. See Figure 36.
Figure 36
Install second spacer. See Figure 37.
Figure 37
Install magnet plate in housing by holding the
magnet inside the housing body, lining up any three
holes, and tightening the three button head torx
screws using a T-15 security torx bit. See Figure 38.
Figure 38
Apply a light film of grease on magnet. See Figure
39.
Figure 39
With torque settings on the housing and torque
index mark on end cap facing you, place housing on
end cap. Use caution as magnets will attract to each
other. Tap in place with soft hammer if necessary.
See Figure 40.
Figure 40
Apply Grease
Torque
Settings
Torque
Index Mark