Asus Barebone System T2-PH2 - Manual (Page 41)

2-21 ASUS T2-PH2
Configure your hard disk drive as Master device before connecting the
IDE cable and power plug. Refer to the HDD documentation on how to
set the drive as a Master device.
2.10 Installing a hard disk drive (HDD)
The system supports one Ultra ATA/100 IDE or one Serial ATA hard disk
drive.
To install an IDE hard disk drive:
1. Locate the HDD tray lock screw
on the other side of the chassis.
2. Remove the lock screw with a
Philips screw driver. Keep the
screw for later use.
4. Place a hard disk drive on the
tray with its bottom on the
open side. Align the HDD and
HDD tray screw holes.
5. Secure the HDD with four
screws.
3. Slide the HDD tray outward until
the tray slots are released from
the chassis hooks.
4
5
5
1
2
Tray locks
Lock slots
3
Tray locks