Asus Barebone System T2-PH2 - Manual (Page 71)

4-13 ASUS T2-PH2
3. Panel connector (8-1 pin PANEL)
This connector supports several chassis-mounted functions through
connection with the motherboard panel connector (36-1 pin). Refer to
the section “10. System Panel Connector (36-1 pin PANEL)” on page
4-11 for details.
• System power LED (2-pin PLED)
This 2-pin connector is for the system power LED. The system power
LED lights up when you turn on the system power, and blinks when
the system is in sleep mode.
• Hard disk drive activity (2-pin HDLED)
This 2-pin connector is for the HDD Activity LED. The IDE LED lights
up or flashes when data is read from or written to the HDD.
• Power/Soft-off button (1-pin PWR)
This connector is for the system power button. Pressing the power
button turns the system ON or puts the system in SLEEP or SOFT-OFF
mode depending on the BIOS settings. Pressing the power switch for
more than four seconds while the system is ON turns the system OFF.
* Requires an ATX power supply.
PWR+
PANEL
PLED
+
GND
PLED
-
NC
HDLED
+
HDLED
-
PWR
PLED HDLED Front panel daughterboard