Asus Barebone System T2-PH2 - Manual (Page 44)

2-24 Chapter 2: Basic installation
2.11 Reinstalling the power supply unit
Reinstall the power supply unit (PSU) after installing the system
components and reconnecting the cables.
To reinstall the PSU:
1. Connect the 4-pin 12 V power
plug to the ATX12V connector
on the motherboard.
2. Connect the 24-pin ATX power
plug to the ATXPWR connector
on the motherboard. See page
4-7 for the location of power
connectors.
3. Position the PSU over the
chassis.
4. Align the PSU side hook with the
metal slot located on the side of
the optical drive bay.
5. Slide the PSU toward the
direction of the rear panel until it
fits in place.
6. Secure the PSU with the screw
you removed earlier.
Make sure the PSU cables do
not interfere with the CPU
and/or chassis fans.
2
1
6
4
3
5