Asus Barebone System T2-PH2 - Manual (Page 42)

2-22 Chapter 2: Basic installation
6. Reinstall the tray and the HDD
to the chassis by locking the
tray slots to the chassis hooks.
7. Secure the tray with the screw
you removed earlier.
8. Connect one end of the 40-pin
IDE cable to the IDE connector
on the drive.
9. Connect a 4-pin power plug
from the power supply unit to
the HDD power connector. See
page 2-25 for details on the
power supply unit plugs.
10. Connect the other end of the
IDE ribbon cable to the primary
IDE connector (blue connector
labeled PRI_IDE) on the
motherboard. See page 4-8 for
the location of the primary IDE
connector.
6
7
8
9