Alpine CDA-W560E - Manual (Page 10)

8
-EN
Repeat Play
The track will be played repeatedly.
1
Press FUNCTION/SETUP to select the FUNCTION
mode.
2
Press / or - to select REPEAT mode, then press
-/J / ENT..
The mode that is blinking at the centre of the display is the
selected mode.
3
Press / or - to select RPT ONE or RPT ALL, then
press -/J / ENT..
The mode that is blinking is the selected mode.
* In changer mode
** “REPEAT” is displayed in CD mode and “RPT” is
displayed in changer mode.
4
To cancel, select RPT OFF with the above
procedure.
• The FUNCTION mode will be cancelled when an operation has
not been performed in 10 seconds.
• Changer Mode
- Specifying “RPT ALL” serves to play the disc repeatedly.
- Setting “RPT ALL” to ON during M.I.X. play will start M.I.X.
play of the current disc.
Searching from CD Text
Tracks can be searched and played from among CD text. In the case
of discs and changers that do not support text, searches can be made
from the track numbers.
1
Press (SEARCH) during play.
This will set the search mode.
2
Press / or - to select the desired track, then
press -/J / ENT..
This will play the selected track.
• Press (SEARCH) in the search mode to cancel. Or, the search
mode will be cancelled when an operation has not been performed
in 10 seconds.
• CD text search cannot be made during M.I.X. play.
Quick Search
You can search for tracks.
Press and hold or to select the desired
track (track number).
The selected track is played back immediately.
• Holding down or causes the track numbers to
change continuously and removing your finger starts playing that
track.
FUNCTION SETUP NORMAL
mode mode mode
RPT ONE RPT ALL RPT OFF
* ** **
(One track repeat) (Disc repeat)