Alpine CDA-W560E - Manual (Page 9)

7
-EN
CD Operation
Playback (CD)
1
Insert a disc with the label side facing up.
The disc will be pulled into the unit automatically.
• Do not attach adapters to CD singles (8 cm) as it may cause
malfunction of the unit.
• When a disc is already inserted, press SOURCE/POWER to switch
to CD mode. Playback starts.
2
Press g , f or , to select the
desired track.
Returning to the beginning of the current track:
Press g or .
Fast backward:
Press and hold g.
Advancing to the beginning of the next track:
Press f or .
Fast forward:
Press and hold f.
3
Press -/J / ENT. to pause playback.
Press -/J / ENT. again to start playback.
4
Press CD c to eject the disc.
Be sure to remove the disc after ejecting.
• Do not remove a CD during its eject cycle. Do not load more than
one disc at a time. A malfunction may result from doing either.
• In the CD/Changer mode, pressing “BAND” will switch the disc
mode.
Scanning Programmes
The first 10 seconds of each track will be played back in succession.
1
Press FUNCTION/SETUP to select the
FUNCTION mode.
2
Press / or - to select SCAN mode, then press
-/J / ENT..
The mode that is blinking at the centre of the display is
the selected mode.
3
Press / or - to select ON, then press -/J / ENT..
• When you have found a desired track for listening, switch the
function OFF with the above procedure.
• The FUNCTION mode will be cancelled when an operation has
not been performed in 10 seconds.
M.I.X. (Random Play)
The tracks on the disc will be played back in random sequence.
1
Press FUNCTION/SETUP to select the
FUNCTION mode.
2
Press / or - to select M.I.X. mode, then press
-/J / ENT..
The mode that is blinking at the centre of the display is
the selected mode.
3
Press / or - to select M.I.X. ONE or M.I.X. ALL,
then press -/J / ENT..
The mode that is blinking is the selected mode.
* In changer modes supporting M.I.X. ALL (Changers supporting
MP3 are not supported in M.I.X. ALL)
4
To cancel, select M.I.X. OFF with the above
procedure.
• The FUNCTION mode will be cancelled when an operation has
not been performed in 10 seconds.
• Changer Mode
- Specifying “M.I.X. ONE” will play all the tracks of the disc in
random order.
- Specifying “M.I.X. ALL” will (randomly) play track by track
while changing between discs. (Only for changers that support
M.I.X. ALL.)
- Specifying “M.I.X. ONE” while playing “RPT ALL” will start
M.I.X. play of the current disc.
FUNCTION/SETUP
f
g
CD c
ON OFF
/ / -
-/J / ENT.
TUNER TAPE CD CHANGER*
(* Only when the changer is connected)
(SEARCH)
FUNCTION SETUP NORMAL
mode mode mode
M.I.X. ONE M.I.X. ALL* M.I.X. OFF
FUNCTION SETUP NORMAL
mode mode mode
SOURCE/POWER