Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 13)

Hybrid Terminal Block Hardware Manual
1-4
1.2 System Design
*1 Up to 63 CANopen slaves, Hybrid Terminal Block, can be connected to the CANopen Master, (GP3000
Series CANopen board type or LT3000 Series using CANopen Master Unit) with CANopen transfer cables
and connectors shown as follows;
GP Interface
(1) CANopen Interface
Recommended Cable Connector:
CiA-recommended CANopen (CiA DR-303-1) -
compatible DSUB 9-pin connector (DIN41652). CANopen Recommended Transfer Cable:
CiA-recommended CANopen (CiA DR-303-1) -
compatible twisted pair cables with shield.
• Please use your own cables or cable connectors with your guarantee.
Model No. Manufacturer Description
Recommended
Cable
Connector
TSXCANKCDF180T <Schneider Electric>
Straight connector with terminal
selector switch attached.
TSXCANKCDF90T
TSXCANKCDF90TP
<Schneider Electric>
Right-angled connector with terminal
selector switch attached.
Only for use for GP-3300 Series
CANopen board type and LT3000
Series using CANopen Master Unit.
VS-09-BU-DSUB/CAN <PHOENIX CONTACT>
Connector with terminal block
attached with terminal selector
switch attached.
SUBCON-PLUS-CAN/AX <PHOENIX CONTACT>
Straight connector with terminal
selector switch attached.
SUBCON-PLUS-CAN/PG
SUBCON-PLUS-CAN
<PHOENIX CONTACT>
Right-angled connector with terminal
selector switch attached.
CANopen
Recommended
Transfer Cable TSX CAN CA50/
TSX CAN CA100
<Schneider Electric>
Cable for CANopen
(IEC60332-1) 50 m/100 m
TSX CAN CB50/
TSX CAN CB100
<Schneider Electric>
UL-authenticated cable for CANopen
(IEC60332-2) 50 m/100 m
• CANopen communication cables and cable connectors are not supplied with the CANopen
Master Unit. Users must prepare cables.
CANopen master,
GP unit etc.
(1) IO Cable
(Prepared by user)
Various types of I/O
equipment
Indicators, LEDs,
sensors, switches,
and so on
7 EX Modules (max.)
*1
•
•
•
HTB
IO Cable
(Prepared by user)
Various types of I/O
equipment
Indicators, LEDs,
sensors, switches,
and so on
7 EX Modules (max.) HTB