Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 32)

Chapter 3 Installation and Wiring
3-7
3.2.2 CANopen wiring
The CANopen interface uses DSUB 9-pin plug connector. The plug is assigned with the CAN_H, CAN_L and
CAN_GND connections. CAN_H and CAN_L are two physically different bus levels. CAN_GND is the
common reference potential.
„Line termination
To minimize the reflections from the end of the cable, a line termination shall be placed close to the 2 ends of
the bus. Connect both ends of the twisted pair cable(CAN_H and CAN_L) to each LT. Use line termination
whose resistance value is 120
Ω. (5%, 1/4 W maximum)
• The cable’s resistance value should be 70m
Ω/m or less.
• The above diagrams shows the case used the cable connector “XM2D-0901” by OMRON Co.
GP
Termination
Resistance
Shield D-sub 9 pin (socket)
CAN-L
Signal
name
2
CAN-H
CAN-GND
FG Shell
3
7
Pin
GP
D-sub 9 pin (socket)
CAN-L
Signal
name
2
CAN-H
CAN-GND
FG Shell
3
7
Pin
Shield
Shield
LT = Line Termination
Node 1 Node 2 Node n
LT
CAN_H
CAN_L
CAN_GND
Twisted Pair Cable
LT
Diagram 1
Diagram 2
Diagram 1 Diagram 2