Proface PS4800 - 19 Panel PC" - Manual (Page 69)

Main Power Connection
69
Wiring and Connecting the Terminal Block (DC power supply connector)
When wiring and connecting the PS-B unit power cables, follow the procedure
below:
Step Action
1 Remove all power from the PS-B unit and confirm that the DC power supply
has been disconnected from its power source.
2 Connect the power cord to the terminal block as shown below:
Insert each pin terminal into its designated hole and tighten the screw with a
small slot screw driver.
Use wire with
z copper conductors only
z cross-section 0.75 mm² to 2.0 mm² (AWG18 to AWG14)
z maximum operating temperature not less than 75 ° C (167 ° F)
3 Place the terminal block in the power connector and tighten the screws. The
recommended torque to tighten these screws is 0.5 N•m (4.5 lb-in):
3RZHUFRUG
7HUPLQDO EORFN
9 )* 9
VFUHZ
7HUPLQDO%ORFN
6FUHZ
6FUHZ
3RZHU&RQQHFWRU
3RZHU&RUG