Proface APL3000B - Node Box PC - Manual (Page 9)

9
DVI Cable Selection Switch
When connecting Pro-face FP3000 Series to PL-3000B series unit, use the Pro-face DVI-D
cable (10m) FP-DV01-100. (Other 10m DVI cables are not supported)
When using FP-DV01-100, change DVI Cable Selection Switch (SW5) settings.
7
Switches the shorting
of SDA and RDA ON or
OFF Shorts SDA and
RDA
(RS-485 mode)
No shorting
(RS-422 mode)
OFF OFF ON
8
Switches the shorting
of SDB and RDB ON or
OFF Shorts SDB and
RDB
(RS-485 mode)
No shorting
(RS-422 mode)
OFF OFF ON
9
RS (RTS) Automatic
control mode
(enabled only when
RS-485 mode) The data is
automatically
controlled via the
RS (RTS) signal. The data is not
automatically
controlled via the
RS (RTS) signal.
OFF OFF
ON/
OFF
*2
10 OFF OFF
ON/
OFF
*2
Serial Mode Select Switches (SW4 to SW10) operate as shown in the circuit diagram below.
*1 Be sure to leave these settings OFF.
*2 Set switches number 9 and 10 to ON when the SD (TXD) output driver is automatically controlled
with RS (RTS). Set switch number 4 to OFF.
Set switches number 9 and 10 to OFF when the SD (TXD) output driver is controlled with the RS
(RTS) signal. Set switch number 4 to ON.
*3 If you use the termination resistance, base your settings on the connection specifications.
Switch
No.
Description ON OFF RS-232C RS-422 RS-485
*2
RT(RTS) Automatic
control
Factory Setting For FP-DV01-100