Proface APL3000B - Node Box PC User Manual
Page 128
Chapter 5 Troubleshooting
5-3
The OS does not operate
properly.
Is [Type] set to [Auto] in the IDE Channel / SATA Port
setting?
Did you connect a new hard disk drive or commercial
USB memory which does not require boot-up?
If this symptom occurs, setting [Power on Delay] to
[Enabled] may solve the problem.
“Delayed Write
Failed” occurs
frequently.
When some of the following conditions occur
simultaneously, there is a high probability that the PL has
failed while writing to files, resulting in this error.
• The same file is frequently accessed (opened, read,
written, etc.).
• The amount of implemented memory is small and
cache memory is insufficient.
• The file is highly fragmented.
• The I/O load to the disk is high.
• Delay writing fails.
Try performing maintenance on the drive. If the problem
continues, replace the drive.
I want to use a LAN to
recover the OS from
standby or sleep
mode.
Set the PL as follows:
1. Select [Control Panel] from the Start menu.
2. Double-click [System]. (With Windows XP, it is in the
[Performance and Maintenance] category.)
3. Click [Device Manager] on the [Hardware] tab.
4. Double-click [Intel PRO/***] in [Network adapters].
5. On the [Power Management] tab, check [Wake on
Magic Packet.].
I did not shut down or
reboot the unit, but
the “CMOS CHECK
SUM ERROR”
occurred.
A possible cause is that clock data backup drained the
battery. Replace the battery. Since the BIOS setting will
be lost when the battery is removed, it should be
configured again after replacing the battery. The following
conditions may accelerate the battery drain.
• The temperature of the surrounding environment
frequently changes from low to high.
• The connected expansion board consumes the clock
data back-up battery quickly.
Problem
Countermeasure and reference page
SEE
IDE Channel / SATA Port (page2-5)
SEE
SEE
SEE
PL3000 Series Hardware Manual
“Maintenance”