Proface APL3000B - Node Box PC User Manual
Page 58
Chapter 2 Specifications
2-31
Switch
No.
Description
ON
OFF
Factory
Settings
Notes
1
Disable/enable Detecting the
middle point during touching
two points simultaneously.
*1
*1
When two points are pushed simultaneously, it is considered that middle point between the two
points is touched according to the nature of the analog resistive touch panel.
If a switch or other part is located on the middle point, it will be detected and may be operated
without any touches. To prevent such a switch from malfunction during two points are pushed
simultaneously, set Switch Number 1 to ON.
Even, drug control could not be operated very smoothly.
Disabled
Enabled
OFF
The middle point is not
considered to be touched
when the SW is ON. It is
considered to be touched
when the SW is OFF.
2
Changes PIO/DMA of CF Card.
PIO+DMA
PIO
ON
3
Changes PIO/DMA of CF Card.
PIO+DMA
PIO
ON
4
Disable/enable Hardware
Reset Switch.
Disabled
Enabled
OFF
The hardware switch is
unavailable when the SW
is ON. But, it is available to
enter switch from the Soft
OFF
*2
state.
*2
The Soft OFF refers to the state that Windows
®
has been shut down and the power is provided
only for the electric circuit to boot system. This Soft OFF State is different from what is System
Standby set by Windows
®
.
5
Able to change a Master/Slave
setting for CF Card slot.
Master
Slave
OFF
*3
*3
When built in Pro-face's Windows
®
XP Embedded, the factory setting is ON.
6
Disable/enable Access to the
Front USB port.
*4
*4
The Setting up an enabled/Disabled state for USB port execution control function is available for
only Windows
®
2000 and Windows
®
XP. Make sure to disable the function of the setting when
other OS used.
Enabled
Disabled
ON
The front USB port is
available when the SW is
ON. It is unavailable when
the SW is OFF.
7
Used for the system.
Reserved
Reserved
OFF
8
Used for the system.
Reserved
Reserved
OFF
As for PS3711A-T42/
PS3711A-T42-24V, the
factory setting is ON.
9
Implements the logical
inversion operation for RAS
output.
Normal
Close
Normal
Open
OFF
RAS output is a CLOSE
state when the SW and the
system is ON. When the
SW is OFF, it is the
opposite. The RAS Output
keeps Normal OPEN when
the Soft OFF
state
occurs or the power turns
OFF.
10
Used for the system.
Reserved
Reserved
OFF
Table 1) System Set Switches