Proface APL3000B - Node Box PC - Manual (Page 91)

PS-3710A/PS-3711A Series Hardware Manual
3-24
(4) After inserting all three pins, insert the Power Plug into the Power Connector at PS-A. Fix the plug with
two (2) slot screws.
DC Power Supply Type Connections
When connecting to PS-3710A Series Power Supply type
Power Cord Specifications
Wiring
When connecting the power cord, use the following items when performing wiring. (Items are made by
Phoenix Contact.
*1
)
*1 For details, please contact your local Phoenix Contact distributor.
• Confirm that all wires are connected correctly.
• The torque required to tighten these screws is 0.5 to 0.6N
•m.
• To prevent the possibility of a terminal short, use a pin terminal that has an
insulating sleeve.
Power Cord Diameter
0.75 to 2.5mm
2
(18 to 12 AWG)
Conductor Type Simple or Stranded Wire
*1
*1 If the Conductor’s end (individual) wires are not twisted correctly, the end
wires may either short against each other, or against an electrode.
Conductor Length
• Use copper conductors only.
Recommended Driver SZS 0.6x3.5 (1205053)
Recommended Pin Terminals
AI 0.75-10GY (3201288)
AI 1-10RD (3200182)
AI 1.5-10BK (3200195)
AI 2.5-12BU (3200962)
Recommended Pin Terminal Crimp Tool CRIMPFOX ZA3 (1201882)
• The power supply connector (plug) is CA7-DCCNL-01 from Pro-face, or GFKC2,5/3-
STF-7,62 (made by Phoenix Contact
*1
).
10mm[0.39in.]