Proface APL3000B - Node Box PC - Manual (Page 74)

Chapter 3 Installation and Wiring
3-7
For PS-3710A Series
Unscrew the five (5) attachment screws used to hold the
Rear Cover in place, and remove the Rear Cover. The
torque of the rear cover required for these screws is 0.5
to 0.6 N • m.
For PS-3711A Series
Unscrew the eight (8) attachment screws used to hold the Rear Cover in place (As for AC Power Supply type,
remove the power cover as shown below), and remove the Rear Cover. The torque of the rear cover required
for these screws is 0.5 to 0.6N • m.
(As for AC Power Supply type, replace the power cover and reattach the screws.)
DC Power Supply type
AC Power Supply type
When
attaching,
replace
Power Cover
and fasten
screws for
AC Power
Supply type.