Yokogawa µR10000 - Manual (Page 108)

IM 04P01B01-01E
5-8
5.1 Settng the Input Range
• Scale Left, Scale Rght, and Decmal Poston
Selectable range (mantissa): –20000 to 30000
Example: The value in the range of –100.00 to 350.00 cannot be specified. The
mantissa of Scale_R is 35000, which exceeds the upper limit of 30000.
Set in the range of –100.0 to 350.0.
Decimal position: XXXXX, XXXX.X, XXX.XX, XX.XXX, X.XXXX
The decimal position is set using Scale_L. It cannot be set using Scale_R.
Example: Change 0.00 to 0.0.
Press the key to move the cursor to the last digit of 0.00.
Space
Press the key to change the value to 0.0 .
• Low-cut and Low-cut Pont
If low-cut is set to On, set the low-cut point.
Selectable range of the low-cut point: 0.0 to 5.0% of the recording span
Values below the low-cut point is set to 0% (scale left value) of the recording span.
Note
• The displayable/printable range of scale values is –19999 to 30000 excluding the decimal.
• If the leftmost value of the scale is set to –20000 (excluding the decimal) and the low-cut
value is set to –20000, the value when the low-cut function is applied is displayed as “–
Over.”
<Related Topcs> Setting the unit: Section 5.3
Enabling the low-cut function: Section 7.15
Skp (Unused Channels)
Select Skip.
Set the channel range.
The new setting takes effect.
First channel Last channel
ESC/?
Set=Range
CH=01-01
Mode=Skip
01-01 Channel
Setting complete
Note
Do not use channels set to skip as a reference channel of delta computations or in computing
equations of the computation function (/M1 option).