Yokogawa µR10000 - Manual (Page 84)

IM 04P01B01-01E
3-16
3.10 Prntng Messages
This section explains the procedure for printing the preset character strings. For the
procedure of setting the character strings, see section 6.8.
Note
• Messages can be printed only during trend recording. However, regardless of whether trend
recording is ON or OFF, messages waiting to be printed are temporarily stored in the buffer
memory.
• Message printouts are not performed when the chart speed is greater than or equal to 1600
mm/h and 101 mm/h on the pen model and dot model, respectively.
Procedure
Prntng a Message
1. Press the
FUNC
key.
2. Press the key to select Message and then press the key.
Func=Message
3. Press the key to select message number and then press the key.
The message printout starts. The screen returns to the data display screen.
Displays the preset message.
Message=Message1
Clearng the Message Prntout Buffer
Messages waiting to be printed are temporarily stored in the buffer memory. This
operation clears the messages in the buffer.
1. Press the
FUNC
key.
2. Press the key to select Buffer clear and then press the key.
3. Press the key to select Message and then press the key.
The messages in the printout buffer are cleared. The screen returns to the data
display screen.
Buf.clear=Message
* When the key or key is pressed while holding down the SHIFT key, the operation is reversed as
when the respective key is pressed by itself.