Yokogawa DAQWORX - Manual (Page 28)

2-4 IM WX13-01E
2.3 Setting Up Projects
5. Enter a password in the New Password and Confirm boxes and click OK.
Note
• The password is used to open the project and cancel the password protection (see section
3.4).
• Enter a password using up to 16 alphanumeric characters. There are no restrictions on the
characters that can be used.
• Do not forget the password (we recommend writing it down for future reference).
Begin Scanning or Recording When Launcher Starts
6. Click one of the option buttons to select the auto startup function.
Off: Disables the auto startup function.
Only scan measurement data: Start scanning when the Launcher is started.
Scan and record measurement data: Start scanning and recording when the
Launcher is started.
7. Click OK.
The settings are saved, and the dialog box closes. The changes you make to the
settings after this point apply to the new project.
Click Cancel to cancel the settings. A new project is not created in this case.
Note
The settings that exist when you quit the Launcher or switch to another project are saved to the
current project.
Copying a Project
Carry out the following procedure to copy the settings of another project to the currently
Selected project.
1. Choose Project Copy from the File menu.
The Copy Project dialog box opens.
2. Choose the copy source project from the list box.
3. Click OK.
The settings of the copy source project are copied to the currently opened project.
Note
This menu cannot be selected if only 1 project has been created (such as the first time using
the program).