Yokogawa DAQWORX - Manual (Page 44)

2-20 IM WX13-01E
2.4 Entering Data Logging Conditions
Display
Set the display format for numeric values. Select floating-point (100.0) or exponential
(1.000E2). Floating-point and exponential toggle each time the box is clicked.
Meter Type
Click one of the option buttons to select the type of meter to be displayed on the meter
monitor of Data Monitor from bar meter, analog meter, and thermometer. The setting is
not used on Historical Viewer.
Scale
• Detail
Select whether to use user settings or server settings for the scale settings.
CH: The max and min values of the channels assigned to the recording start
time are obtained from the monitor server and set to the scale max and min
values.
USER: The values entered into the box are set as the max and min values.
When selecting USER, you can change the max and min value settings.
• Max. value, min. value
Click the value boxes to enter the maximum and minimum values of the scale.
The range of values that can be entered is from –999999999 to 999999999 excluding
the decimal point.
If you set the minimum value larger than the maximum value, the waveform is
inverted.
Note
The decimal point position of the entered value is adjusted according to the number of
significant digits to the right of the decimal point.
Zone
Click the value boxes to enter the maximum and minimum values of the waveform
display zone. The range of values that can be entered is 0 to 99% for the minimum value
and 1 to 100% for the maximum value.
Trip 1 and Trip 2
Click the value box and enter the position of the trip line within the scale range.
When you enter a value, the check box turns blue. If you do not wish to use the trip line,
clear the check box.
Blue: Enable.
Gray: Disabled.
Note
Trip line 1 and 2 are displayed in red and blue, respectively.