Pro-Cut PFM 9.2 - Manual (Page 20)

PG / Ø38 800.543.6618 WWW.PROCUTUSA.COM PG / Ø39
DRO EFFICIENCY TRACKING
This value represents the total number of completed
compensation cycles. Estimating one cycle per cut,
we can begin to establish ROI.
DRO DIAGNOSTICS CONTINUED
Press the START button again and the word "5 Adj." screen will be displayed. Press the START button once more and the
last five adjustment cycle times will be displayed in seconds. Press the START button once more and you will reach the
units display toggle. Pressing 'Start' will toggle between inch and metric (mm for thickness and microns for runout) display
modes. Press the START button one more time to enter Thickness Calibration mode. This is for G2X equipped lathes. Further
information is found on page 50.
Press the START button again and the word "Total" will be displayed. Press the START button once more and the
total number of times the machine has compensated will be displayed.
Press the START button once more and the "A.Adj." will be displayed. Press the START button once again and the
average adjustment (compensation) time over the course of the total number of compensations the machine has
completed will be displayed in seconds. (Following Page)
DRO DIAGNOSTICS
This value represents the average compensation
time recorded in seconds over the life of the lathe.
Display of average compensation time of the last 5
successful compensation cycles.