Pro-Cut PFM 9.2 - Manual (Page 27)

PG / Ø52 800.543.6618 WWW.PROCUTUSA.COM PG / Ø53
G2X TROUBLE SHOOTING G2X SERVICE CONSIDERATIONS
A properly set up and adjusted 50-1200 cutting head will provide smooth yet firm arm motion with minimal knob
backlash. If you are having difficulty turning the dials when the arm knobs are backed off, or if the dials turn very
easily then adjustments need to be made to the assembly. A poorly adjusted cutting head can cause poor rotor
surface finish.
The most common cause of poor dial feel is mis-adjustment of the tool arm gibs. Like the slideway gib adjustment
there is a nut and a set screw. The nut must be loosened and the set screw tightened to remove any play between
the arm and the arm guide, but it must also not be overly tight. The nuts are all-steel lock nuts, so they turn firmly.
Once the set screw is properly adjusted the lock nut must be tightened without disturbing the set screw position.
Adjust both arms until you have firm but smooth dial feel. If you have trouble with this procedure please contact
Pro-Cut's service department and we will be happy to help.
Power off the lathe by unplugging it.
Re-seat these cables firmly.
Power the lathe on.
No Thickness Measurement Data.
One of the white rectangular cables connect to the device under the feed mechanism
are partially or not fully connected. To solve this:
ISSUE
TROUBLESHOOT
1.
2.
3.