Troubleshooting and calibration – Pro-Cut PFM 9.2 User Manual
Page 35
PG /
Ø68
800.543.6618
WWW.PROCUTUSA.COM
PG /
Ø69
TROUBLESHOOTING AND CALIBRATION
GYR is a fast, automated rotor matching system for making in-spec brake repairs while
capturing rotor thickness and runout metrics. However, things can go wrong; mistakes
can be made. The following troubleshooting guide will help you diagnose issues before
you give us a call. If you cannot diagnose your issue after following the troubleshooting
guide, please call us at:
1.800.543.6618
LATHE/PC will not communicate. Screen lower left reads “Disconnected.” Motor does turn on.
1. CHECK ALL WIRING CONNECTIONS. After making sure all are connected, cycle
the AC power to the lathe by unplugging it from the wall and plugging it in again.
2. At the lathe computer box, unplug the USB cable, wait a few seconds and then
re-seat the USB cable.
GYR TROUBLESHOOTING GUIDE
ISSUE
TROUBLESHOOT
Lathe will not run; computer is on.
1. Check power cord connections.
2. Check shut-off cam.
ISSUE
TROUBLESHOOT
Scanner will not respond
1. Check the scanner's USB cable connections.
2. Clean vehicle’s barcode / windshield.
3. Vary barcode scanner distance.
4. Approach barcode with scanner at a 30-degree angle.
ISSUE
TROUBLESHOOT