Pro-Cut PFM 9.2 - Manual (Page 33)

OTHER VEHICLE MANUAL ENTRY OF A VEHICLE
If the vehicle does not have a bar code, or you are unable to successfully read the VIN with the scanner, then
you can manually enter the vehicle information by selecting year, make, and model from the drop down menus.
The GYR application not only includes the LRO and thickness specifications, but also includes other needed
around the wheel information such as: Tire size, tire pressure, wheel nut torque, brake caliper bolt torque, etc…
Once the first side is complete, move to the other side and complete the second rotor on that axle. You will
need to rotate the lathe 180 degrees as per the instructions in the lathe owner’s manual.
Follow the same process for the second rotor, scratching the rotor, marking the beginning thickness, cutting
to the appropriate depth, and saving the results.
You may now print the results by touching the “Print” button in the lower left hand corner of the screen. The
printed results can now be shared with the customer or can be used for warranty documentation. 19.
20.
21.
During the cut, the GPM (gage pick-up module) unit mounted under the cutting head gear box listens for
the cut and will cause the “Cut in Progress” alert to be displayed in the yellow command bar.
Once the cutting tips clear the rotor and the cut is complete the “Cut Completed” message will be dis-
played in the command bar.
SERVICE CORRIDOR CONCEPT CONTINUED
16.
17.
18. You may select the “save result” button which will
bring up the “Select Wheel” dialog box giving you
the opportunity to confirm the corner of the vehicle
you just completed and allowing you to save the
results.
If you do nothing, the “Select Wheel” box will pop
up automatically after approximately 30 seconds.
The saved data is now displayed on the screen in
the appropriate corner of the vehicle. Confirm the
correct wheel and select "okay".
NOTE:
Pressing "Save Result" opens the "SELECT WHEEL" dialog box. SAVE RESULT
BUTTON
NOTE:
PG / Ø64 800.543.6618 WWW.PROCUTUSA.COM PG / Ш65