Pro-Cut PFM 9.2 - Manual (Page 8)

PG / Ø14 800.543.6618 WWW.PROCUTUSA.COM PG / Ø15
Before you begin setting up, check contents
against the parts diagram enclosed in the
lathe package. If you are missing any parts,
call Pro-Cut immediately.
SETTING UP A NEW LATHE
ASSEMBLE THE TROLLEY
Open the trolley box and check contents against the parts diagram . If you are missing any parts, call Pro-Cut
immediately. Proceed with assembly, following the instructions enclosed in the box.
MOUNT THE LATHE TO THE TROLLEY
Once the trolley is assembled you will need to mount the lathe to the trolley. Locate lathe arm on trolley so
that lathe will be in upright horizontal position when it is installed, then lock the disc-lock lever firmly.
1 ) Remove the lathe body from the shipping pallet and install mounting studs under lathe in two threaded
holes the pallet bolts were removed from.
2 ) Find another person to help lift the lathe using the handles on either end, and insert the lathe mounting
studs into trolley arm. Secure with two nuts (36-001B) and flat washers (37-108).
3 ) Assemble Guard to Lathe if so equipped. See Page 48 for assembly drawing of Guard 50-1730.
Guard 50-1730 is mandatory in the Province of Quebec.
Assemble the trolley com-
pletely then get assis-
tance from another person
to mount the lathe on the
trolley.
Cutting
Edge
Tip