Brocade VDX 8770-8 Hardware Reference Manual - Manual (Page 82)

62 Brocade VDX 8770-8 Hardware Reference Manual
53-1002564-04
Cable management comb removal and replacement
5
Cable management comb removal and replacement
The Brocade VDX 8770-8 can continue to operate during the replacement of the cable
management comb. Refer to
Figure 19 .
Time and items required
The replacement procedure for the cable management comb takes less than 5 minutes. A #1
Phillips screwdriver is required.
Removing a cable management comb
Complete the following steps to remove the cable management comb.
1. Remove the cables from the cable management comb and rearrange the cables around the
comb.
2. Unscrew and save the four (4) screws holding the cable management comb to the chassis.
Retain the screws. Support the cable management comb to prevent it from falling.
3. Remove the cable management comb.