Removing an ac power supply – Brocade VDX 8770-8 Hardware Reference Manual User Manual
Page 93
Brocade VDX 8770-8 Hardware Reference Manual
73
53-1002564-04
Power supply removal and replacement
5
Removing an AC power supply
For the following procedure, refer to
To remove a power supply, complete the following steps.
1. Perform the appropriate following action based on whether the Brocade VDX 8770-8 is
operating:
•
If the Brocade VDX 8770-8 is not operating during the replacement procedure, go to step
2.
•
If the Brocade VDX 8770-8 is operating and will continue to operate during the
replacement, check the power LEDs to verify that the minimum number of power supplies
is functioning. Refer to
to check your power requirements.
2. Unlatch the power cord retainer clip.
3. Remove the power cord.
4. Loosen the captive screw.
5. Push down on the handle to eject the power supply.
6. Grasp the handle and pull, sliding the power supply from the chassis and supporting the power
supply from beneath as you remove it.