Brocade Multi-Service IronWare QoS and Traffic Management Configuration Guide (Supporting R05.6.00) - Manual (Page 42)

28 Multi-Service IronWare QoS and Traffic Management Configuration Guide
53-1003037-02
Traffic policing on the Brocade device
2
Resetting the rate limit counters
You can reset all of the rate limit counters using the following command.
Brocade# clear rate-limit counters
Syntax: clear rate-limit counters [interface]
The interface variable specifies an interface that you want to clear the rate limit counters for. If you
do not specify an interface, all rate limit counters on the device will be reset.
Displaying information about rate limit VLAN groups
To display information about rate limit VLAN groups, enter the following command.
Brocade# show rate-limit group
Syntax: show rate-limit group
Output such as the following will display
rl-vlan-group 1
vlan 10 to 15
This display shows the following information.
Displaying rate limit policies per interface
To display information about rate limit policies that are configured per interface, enter the following
command.
Brocade# show rate-limit
Syntax: show rate-limit
Output such as the following will display.
Brocade(config-if-e10000-1/1)#show rate-limit
interface e 1/1
rate-limit input 959904 2000000
rate-limit output 2986368 2000000
This display shows the following information.
Displaying rate limit policies configured in policy maps
To display information about rate limit policy maps, enter the following command.
Brocade# show policy-map
TABLE 9 Rate limit VLAN group parameters
This field... Displays...
rl-vlan-group The VLAN group whose contents are displayed.
vlan VLANs contained in the VLAN group specified.
TABLE 10 Rate limit interface parameters
This field... Displays...
rate-limit input The average-rate and maximum burst rate configured for inbound traffic on the
specified interface.
rate-limit output The average-rate and maximum burst rate configured for outbound traffic on
the specified interface.