Brocade Multi-Service IronWare QoS and Traffic Management Configuration Guide (Supporting R05.6.00) - Manual (Page 62)

48 Multi-Service IronWare QoS and Traffic Management Configuration Guide
53-1003037-02
Configuring QoS
3
Configuring force priority to the DSCP value
You can configure an ingress port (using the qos dscp force command) to force the configured
DSCP value when determining the priority relative to other priority values of incoming packets.
To configure an ingress port to force the DSCP value, use the qos dscp force command as shown in
the following.
Brocade(config)# interface ethernet 10/1
Brocade(config-if-e10000-10/1)qos dscp force
Syntax: [no] qos dscp force
Configuring force priority to the PCP value
You can configure an ingress port (using the qos pcp force command) to force the configured PCP
value when determining the priority relative to other priority values of incoming packets.
To configure an ingress port to force the PCP value, use the qos pcp force command as shown in
the following.
Brocade(config)# interface ethernet 10/1
Brocade(config-if-e10000-10/1)qos pcp force
Syntax: [no] qos pcp force
Configuring force priority to a value specified by an ACL
You can use the priority-force keyword within an ACL to apply a priority to specified traffic as
described in “Filtering and priority manipulation based on 802.1p priority” in the Multi-Service
IronWare Security Configuration Guide.