Brocade 300 Hardware Reference Manual - Manual (Page 38)

Memory Specifications TABLE 10
Memory Type Installed Memory
Main memory (SDRAM) 512 MB
Compact flash 1 GB
Fibre Channel port specifications
The Fibre Channel ports in the Brocade 300 are compatible with SWL, LWL, and ELWL SFPs. The
strength of the signal is determined by the type of SFP in use.
The ports meet all required safety standards. For more information about these standards, see
Regulatory compliance on page 39.
The ports are capable of operating at 1, 2, 4 and 8 Gbps, and are able to autonegotiate the highest
speed capable for all attached devices.
Serial port specifications
The serial port is located on the port side of the switch as a RJ-45 connector, designed to connect to a
DTE port.
Use the serial port to connect to a computer workstation to configure the switch IP address without
connecting to the fabric. The serial port’s parameters are 9600 baud, 8 data bits, no parity, 1 stop bit,
and no flow control.
Supported SFPs and HBAs
When you receive the Brocade 300, your package contains at least 8 Brocade-branded SFPs for the
base configuration. Use only SFPs that are tested and supported.
For the most up to date list of supported SFPs and HBAs for the Brocade 300, check Brocade
Connect. Using a web browser, connect to www.brocade.com and click the Brocade Connect link.
Fibre Channel port specifications
38 Brocade 300 Hardware Reference Manual
53-1000862-06