Brocade Network Advisor SAN Installation and Migration Guide (Supporting Network Advisor 12.3.0) - Manual (Page 22)

6 Brocade Network Advisor SAN Installation and Migration Guide
53-1003158-01
System requirements
1
NOTE
It is recommended that you add an additional 100 GB of disk space if you use sFlow.
NOTE
If you enable periodic supportSave or configure the Network Advisor server as the Upload Failure
Data Capture location for monitored switches, then additional disk space will be required. Each
switch supportSave file is approximately 5 MB and each Upload Failure Data Capture file is
approximately 500 KB. To determine the disk space requirements, multiply the frequency of
scheduled supportSave files by 5 MB and the expected Upload Failure Data Capture files by 500 KB
before the planned periodic purge activity.
Table 7 summarizes the host, memory and disk space requirements for remote client.
TABLE 7 Host, Memory, and Disk space requirements for remote client
Resources Required
RAM 4 GB
Processor Core 2 core CPU
Disk space 1 GB
Table 8 summarizes the minimum system requirements for installation.
TABLE 8 Minimum system requirements for installation
Resources Professional Edition Enterprise Edition
RAM 4 GB(32-bit) 6GB (64 bit) 6 GB
Processor Core (including
physical and logical core) 2 core 2 core
Disk space 10 GB 20 GB
Table 9 summarizes the recommended system requirements for installation.
TABLE 9 Recommended system requirements for installation
Resources Small Medium Large
RAM 16 GB 16 GB 16 GB
Processor Core (including
physical and logical core) 2 core 4 core 8 core
Disk space 20 GB 80 GB 100 GB
NOTE
You must have 16 core processor when managing 9000 SAN ports or above.
NOTE
It is recommended to allocate a minimum of 2 GB client memory and 6 GB server memory to
efficiently manage more than 9000 ports.