Brocade Network Advisor SAN Installation and Migration Guide (Supporting Network Advisor 12.3.0) - Manual (Page 73)

Brocade Network Advisor SAN Installation and Migration Guide 57
53-1003158-01
Chapter
4
Uninstallation
In this chapter
• Uninstalling from Windows systems. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 57
• Uninstalling from Windows systems (headless uninstall). . . . . . . . . . . . . . . 58
• Uninstalling from UNIX systems . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 58
• Uninstalling from UNIX systems (headless uninstall) . . . . . . . . . . . . . . . . . . 59
This section provides step-by-step instructions to uninstall Network Advisor and SMI Agent from
both Windows and UNIX systems.
NOTE
Network Advisor is installed on a separate directory from your previous version; therefore, you do not
need to uninstall the previous version immediately. However, you cannot run both versions
simultaneously.
Uninstalling from Windows systems
Follow these instructions to uninstall the Network Advisor and SMI Agent from your Windows
system.
1. Select Start > Programs > Network Advisor 12.3.0 > Uninstall Network Advisor.
2. Select one of the following options on the Uninstall Option screen:
• Partial Uninstall — Configuration and performance data is retained to be re-used by the
new installation. This is the default option.
• Full Uninstall — All data is removed.
3. Click Uninstall.
4. Click Done on the Uninstall Complete screen.