Brocade Network Advisor SAN Installation and Migration Guide (Supporting Network Advisor 12.3.0) User Manual
Page 36
20
Brocade Network Advisor SAN Installation and Migration Guide
53-1003158-01
Configuring Network Advisor
2
f.
Enter a port number in the SNMP Port Number field (default is 162).
g. Enter a port number in the TFTP Port Number field (default is 69).
h. Click Next.
If you enter a syslog port number already in use, a message displays. Click No on the
message to remain on the Server Configuration screen and edit the syslog port number.
Click Yes to close the message.
If you enter a port number already in use, a Warning displays next to the associated port
number field. Edit that port number and click Next.
If you are configuring Professional software, go to
10. (SAN with SMI Agent) Complete the following steps on the SMI Agent Configuration screen.
a. Enable the SMI Agent by selecting the Enable SMI Agent check box.
b. Enable the SLP by selecting the Enable SLP check box, if necessary.
Only enabled after you select the Enable SMI Agent check box.
c. Enable the SSL by selecting the Enable SSL check box, if necessary.
Only enabled after you select the Enable SMI Agent check box.
d. Enter the SMI Agent port number in the SMI Agent Port # field (default is 5989 if SSL
Enabled is selected; otherwise, the default is 5988).
e. Click Next.
11. (SAN Enterprise or SMI Agent) Select one of the following options on the SAN Network Size
screen and click Next:
NOTE
Port count is equal to the total number of switch ports across all fabrics.
NOTE
SAN with SMI Agent + IP edition is not supported on a 32-bit Windows system.
•
Small (managing up to 2000 switch ports, 1-20 domains)
•
Medium (managing up to 5000 switch ports, 21-60 domains)
•
Large (managing up to 15000 switch ports, 61-120 domains)
NOTE
For full performance and dashboard functionality, the Large option of the SAN Enterprise
edition only supports 5000 switch ports on a 32-bit system.
12. Enable feature usage data transfer from the application by selecting the Yes, I want to
participate option.
If you do not want to participate in feature usage data transfer, make sure the No, Thank You
option is selected. You can stop participating at any time. To view an example of the usage
data, click View Example Data.
To stop participating in feature usage data transfer after configuration, refer to