Step 6 – Brocade Network Advisor SAN Installation and Migration Guide (Supporting Network Advisor 12.3.0) User Manual
Page 33
Brocade Network Advisor SAN Installation and Migration Guide
17
53-1003158-01
Configuring Network Advisor
2
6. Complete the following steps on the FTP/SCP/SFTP Server screen.
a. Choose one of the following options:
•
Select Built-in FTP/SCP/SFTP Server (default) to configure an internal FTP/SCP/SFTP
server and select one of the following options:
-
Select Built-in FTP Server to configure an internal FTP server
This is the default option. The internal FTP server uses a default account and
port 21. You can configure your own account from the Options dialog box. For
instructions, refer to the Network Advisor User Manual or online help.
-
Select Built-in SCP/SFTP Server to configure an internal SCP/SFTP server
The internal SCP/SFTP server uses a default account and port 22. You can
configure your own account from the Options dialog box. For instructions, refer to
the Network Advisor User Manual or online help.
•
Select External FTP/SCP/SFTP Server to configure an external FTP server.
You can configure the external FTP server settings from the Options dialog box. For
instructions, refer to the Network Advisor User Manual or online help.
b. Click Next.
If port 21 or 22 is busy, a message displays. Click OK to close the message and continue. Once
the Management application is configured make sure port 21 or 22 is free and restart the
Server to start the FTP/SCP/SFTP service.
NOTE
If you use an FTP/SCP/SFTP server that is not configured on the same machine as the
Management application, the Firmware Repository feature will not be available.
You can configure the FTP/SCP/SFTP server settings from the Options dialog box. For
instructions, refer to the Network Advisor User Manual or online help.
7. Configure the database password on the Database Administrator Password (dcmadmin)
screen by completing the following steps.
a. Choose one of the following options:
•
To use the default password, select Default password.
This is the default option. The default is password.
•
To configure a new password, select New password and enter a new password in the
Password and Confirm Password fields.
The password must be between 8 and 15 alphanumeric characters. Special
characters except single quote (‘) are allowed.
b. Click Next.