Brocade Network Advisor SAN Installation and Migration Guide (Supporting Network Advisor 12.3.0) User Manual
Page 68
52
Brocade Network Advisor SAN Installation and Migration Guide
53-1003158-01
Migrating data
3
10. Complete the following steps on the Server Configuration screen.
FIGURE 2
Server Configuration screen
a. Enter a port number in the Web Server Port # (HTTPS) field (default is 443).
b. Enable HTTP redirection to HTTPS by selecting the Redirect HTTP Requests to HTTPS
check box.
When you enable HTTP redirection, the server uses port 80 to redirect HTTP requests to
HTTPS. You can configure the server port settings from the Options dialog box (Server Port
pane). For instructions, refer to the Network Advisor User Manual or online help.
c. Enter a port number in the Database Port # field (default is 5432).
NOTE
Do not use a port number below 1024.
d. Enter a port number in the Starting Port # field (default is 24600).
NOTE
For Professional software, the server requires 15 consecutive free ports beginning with
the starting port number.
NOTE
For Trial and Licensed software, the server requires 18 consecutive free ports beginning
with the starting port number.
e. Enter a port number in the Syslog Port # field (default is 514).
NOTE
If the default syslog port number is already in use, you will not receive any syslog
messages from the device. To find and stop the process currently running on the default
Syslog port number, refer to