Hired-Hand RollSeal Sidewall System (Curtain): SideWall Curtain - Manual (Page 13)

Part No. 4801-5072 Rev 9-08 SideWall Curtain Page 13
2. Important! There is a hook and loop strip laminated to each pipe section. Keep the
hook & loop strips lined up when connecting the pipe sections in order to form a
continuous strip running the entire length of the drive pipe.
Start at one end. Couple pipe sections together by sliding the swedged end of one section into
the adjacent pipe. (Note: It might be necessary to take a hammer and straighten out the
dimples in the ends of the pipes which were created when the pipe sections were cut). Attach
the sections together by installing stainless steel pop rivets.
3. Pop rivet installation: Drill 3/16 in. (0.48 cm) dia. holes through the pipe and swedged end
which form a junction of two pipe sections. At each junction, drill two holes about 2 in. (5
cm) apart on each side of the pipe as shown in the diagram above. Insert pop rivets through
these holes to fasten the pipe sections together.
IMPORTANT! IF INSTALLING RIDDER MOTOR SKIP TO SECTION
8.10, IF INSTALLING LOCK MOTOR SKIP TO SECTION 8.11.
8.9 Somfy Motor Installation
8.9.1 Somfy Motor Mount and Bearing Mount Installation
Attach the motor mount to either the left track or the right track depending on which end of the
sidewall assembly the motor is to be located (Figure 10). Install four bolts and nuts through the
holes of the motor mount and through the respective holes of the guide bracket. Tighten nuts
securely. The bearing mount installs on the opposite end of the sidewall assembly from the motor
mount. The bearing mount attaches to the guide bracket of the end track using bolts and nuts in
the same way as the motor mount.
Install stainless steel pop rivets
FIGURE 10
Attachment Of Somfy Motor Mount
Somfy motor mount
On end where motor
will be located, attach
the motor mount to the
guide bracket.
Note: Attach bearing mount to
opposite end of assembly
using the same procedure.