Hired-Hand RollSeal Sidewall System (Curtain): SideWall Curtain User Manual
Page 18
Part No. 4801-5072 Rev 9-08
Side Wall Curtain
Page 18
8.10.3
Drive Pipe Connection For Ridder Motor
NOTE: Two drive pipes may be attached to motor as shown in Fig. 16 & Fig. 20.
1. Fit end of drive shaft into sprocket (a). IMPORTANT! Make sure that end of drive shaft
is flush with end of sprocket. Weld pieces together (b).
2. Measure 1.5" (3.81 cm) from one end of drive pipe. Mark pipe. Measure 4.5" (11.43
cm) from end of pipe in line with first mark. Mark pipe. Drill 3/8" (0.95 cm) hole in
pipe at each mark.
3. Slide drive insert assembly into end of drive pipe. Align two holes of drive insert with
holes in drive pipe. Fit drive insert flush with end of drive pipe.
1.5"
(3.8 cm)
4.5"
(11.4 cm)
Drive pipe
Figure 18
Drill holes in drive pipe
Drive
insert
Drive pipe
Align holes in drive pipe
with holes in insert
Figure 19
Fit insert into drive pipe
a
b
Weld on this
side only
Figure 17
Weld sprocket to shaft
Flush shaft
even with face
of sprocket