Hired-Hand RollSeal Sidewall System (Curtain): SideWall Curtain User Manual
Page 22
Part No. 4801-5072 Rev 9-08
Side Wall Curtain
Page 22
M10xSS Bolt
Drive Shaft
M10 Lock Nut
Sprocket
8.11.3
Drive Pipe Connection for Lock Motor
NOTE: Two drive pipes may be attached to motor as shown in Fig. 24 and Fig. 28.
1. Fit end of drive shaft into sprocket (a). IMPORTANT! Make sure that end of drive shaft
is flush with end of sprocket. Tighten the Set Screw (b).
2. Measure 1.0" (2.54 cm) from one end of drive pipe. Mark pipe. Measure 2.5" (6.35 cm)
from end of pipe in line with first mark. Mark pipe. Drill 3/8" (0.95 cm) hole in pipe at
each mark.
3. Slide drive insert assembly into end of drive pipe. Align two holes of drive insert with
holes in drive pipe. Fit drive insert flush with end of drive pipe.
1.0"
(2.54 cm)
2.5"
(6.35 cm)
Drive pipe
Figure 26
Drill holes in drive pipe
Figure 25 Assemble
Shaft and Sprocket
a
Figure 27
Fit insert into drive pipe
Align holes in drive pipe
with holes in insert
Drive
insert
Drive pipe