Hired-Hand RollSeal Sidewall System (Curtain): SideWall Curtain - Manual (Page 8)

Part No. 4801-5072 Rev 9-08 SideWall Curtain Page 8
8.2 Left track
1. Refer to Fig. 4. Starting at the left end,
install the left track. Align the left-hand edge
of the track unit with the left-hand edge of
the backplate.
2. Locate second row of holes from the top of
the back plate. Match the first hole of
backplate with the topmost hole of the left
track as shown in Fig. 4. Note that the bent
vertical edges of track units make contact
underneath the bottom edge of the backplate.
3. Install a lag screw to hold left track in
position. Leave screw loosely attached to
allow left track to have freedom of
movement. NOTE: It is suggested to install
remaining screws after installing all bottom
channels (Section 8.6).
Figure 4
Left Track
Backplate
NOTE: Align top holes of
left track with second
holes from top of back
plate and install lag
screws.
Keep edges of track at
edge of filler board. Note
that bent vertical edges of
vertical members make
contact underneath edge
of backplate.
Figure 3
Backplate
Leave these holes
open at each end
of back plate. Insert 1/4 x 1.5 lag screws
(part no. 1004-5017) through
topmost holes at each end of
back plate.
Position top edge of back
plate flush with top of
board.
Back
plate
2"x 6"
board
Add lag screws through top of
backplate into board to improve
fastening.