Hired-Hand RollSeal Sidewall System (Curtain): SideWall Curtain - Manual (Page 15)

Part No. 4801-5072 Rev 9-08 Side Wall Curtain Page 15
8.9.5 Somfy Motor Electrical Connection & Testing
1. See Section 9.1 "Somfy Motor Tester Wiring Diagram" for description of test cable.
Construct test cable and connect the test cable to the motor cable, match the wire colors and
connect the power.
2.
Remove yellow protective cap from limit switch adjustment buttons.
3. Press both limit switch adjustment buttons in (they will automatically remain locked).
4.
Check that motor rotates properly when switch is turned on.
5. Disconnect electrical power while installing curtains.
Caution!
When the limit switch adjustment buttons are pushed in, the motor has
No stop shut-off points. The number of revolutions is unlimited.
Warning!
Do not wire two or more motors to one switch without using a relay.
W h i t e
R e d
B l a c k
G r e e n
1
2
3
4
Figure 13 Somfy recommends using a test
cable to set the motor limits, and
to ensure the system is operating
properly before the final electrical
connection is made.
(Neutral)
(Clockwise)
(Counterclockwise)
(Earth Ground)
See Section "Somfy Motor
Tester Wiring Diagram" for
test cable.