Hired-Hand RollSeal Sidewall System (Curtain): SideWall Curtain User Manual
Page 28
Part No. 4801-5072 Rev 9-08
Side Wall Curtain
Page 28
Figure 38 Exploded view showing attachment
of two drive pipes to gear box.
8.12 Sidewall 21-1 Manual Drive
1. Refer to Section 8.11.3 Figures 26 and 27 for instructions on placing the drive insert into the drive
pipe.
2. Refer to Fig. 38. Insert drive shaft into the drive insert. Rotate drive shaft to align groove in shaft
with two screws in drive insert.
3. Install lock screws through holes. Do not tighten lock screws at this time. The drive shaft must
move freely in the drive insert.
4. Mount the gear box to the mounting bracket with the supplied hardware.
5. See Fig. 38. Attach the pinion sleeve to the gear box and to the drive shaft. Install the hardware
in the pinion sleeve.
6. Align the gear box and tighten the lock screws from Step 3 above.
Drive Pipe
Lock Screws
Drive Shaft
Pinion Sleeve
Mounting Bracket
Gear Box
Drive Pipe
Drive Insert
Drive Shaft
Pinion Sleeve
Drive Pipe