LT Security LTN7616-HT (Hybrid) - Manual (Page 126)

User Manual of Digital Video Recorder
125
2. Select the NTP tab to enter the NTP Settings interface.
Figure 9. 13 NTP Settings Interface
3. Check checkbox to enable NTP.
4. Configure the following NTP settings:
•
Interval: Time interval between the two synchronizing actions with NTP server. The unit is
minute.
•
NTP Server: IP address of NTP server.
•
NTP Port: Port of NTP server.
5. Click to save and exit the interface.
Note: The time synchronization interval can be set from 1 to 10080min, and the default value is 60min. If the
device is connected to a public network, you should use a NTP server that has a time synchronization function,
such as the server at the National Time Center (IP Address: 210.72.145.44). If the device is setup in a more
customized network, NTP software can be used to establish a NTP server used for time synchronization.
9.2.4 Configuring SNMP Settings
Purpose:
You can use SNMP protocol to get device status and parameters related information.
Steps:
1. Enter the Network Settings interface.
Menu > Configuration > Network
2. Select the SNMP tab to enter the SNMP Settings interface.
Figure 9. 14 SNMP Settings Interface
3. Check checkbox to enable SNMP.
4. Configure the SNMP settings.