LT Security IPPTZ762 - Manual (Page 103)

User Manual of IR High-Definition Network Speed Dome 102
10.7 RS-485 Settings
Purpose:
The RS-485 serial port is used to control the PTZ of the camera. The configuring of
the PTZ parameters should be done before you control the PTZ unit.
Steps:
1. Enter RS-485 Port Setting interface:
Configuration> Advanced Configuration> System > RS485
Figure 10-14 RS-485 Settings
2. Set the RS-485 parameters and click to save the settings.
By default, the Baud Rate is set as 9600 bps, the Data Bit is 8, the stop bit is 1 and
the Parity and Flow Control is None.
The Baud Rate, PTZ Protocol and PTZ Address parameters of the speed dome should
be exactly the same as those of the remote control device.