Alcatel-Lucent Omni 6624 - Manual (Page 74)

Viewing Basic Chassis Information OmniSwitch 6600 Series Chassis and Hardware Components
page 2-54 OmniSwitch 6600 Series Hardware Users Guide April 2004
Slot and Component Information
To view basic slot position and component information, enter the show module command at the CLI
prompt. This command displays the following information:
• Current slot position
• Alcatel part number
• Serial number
• Hardware revision level
• Manufacture date(s)
• Model name, also referred to as chassis type
For example:
-> show module
HW Mfg
Slot Part-Number Serial # Rev Date Model Name
-------+--------------+------------+---+-----------+----------------------------
CMM-1 902098-10 2313283p 210 FEB 05 2106€ OS6648
NI-1 902098-10 2313283p 210 FEB 05 2106€ OS6648
The Slot column lists both the main PCB (CMM) and 10/100 Ethernet bay (NI), along with the switch’s
current slot position. CMM-1 and NI-1 indicates that the switch and its corresponding 10/100 Ethernet bay
(a virtual Network Interface card) have been assigned to slot position 1.
For complete descriptions of the command output, refer to the OmniSwitch CLI Reference Guide.
Stacked Configurations. You can use the show module command to display information for all switches
in a stack, or for a specified switch only. When the show module syntax is entered with no specified slot
number, information for all switches displays. When a slot position is specified in the command line
(e.g., 3), information displays for the corresponding switch only. For detailed information on stacked
OS6600 series switches, refer to
Chapter 3, “Managing OmniSwitch 6600 Series Stacks.”