Alcatel-Lucent Omni 6624 - Manual (Page 29)

OmniSwitch 6600 Series Chassis and Hardware Components OmniSwitch 6648
OmniSwitch 6600 Series Hardware Users Guide April 2004 page 2-9
OmniSwitch 6648
The OS6648 is a stackable edge/workgroup switch offering 48 10/100 Ethernet ports. The OS6648 can
also be equipped with up to four Gigabit Ethernet ports for connections to a high speed backbone or
server.
The front panel of the OS6648 chassis contains the following major components:
• Console (DB-9) port
• Stack indicator LED
• 48 10/100 Ethernet ports
• One slot for OS6600-GNI-U2 (fiber) or OS6600-GNI-C2 (copper) Gigabit Ethernet uplink module
• One slot for Gigabit Ethernet uplink module as described above or stacking module
Refer to the illustration below for more front panel information. For detailed LED descriptions, refer to
page 2-11 . For information on the chassis rear panel, refer to page 2-12 .
OmniSwitch 6648 Front Panel
CONSOLE
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
1
2
EXPANSION/STACKING
EXPANSION
49 5 0 5 1 5 2
TM
OmniSwitch 6648
OK1
OK2
PS1
PS2
PRI
SEC
TEMP
FAN
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
25
26
LINK/ACT LINK/ACT
LINK/ACT LINK/ACT
SEL
10/100 Ethernet Ports
The OS6648 provides 48 10/100
Ethernet ports. These ports are
twisted-pair and are individually
configurable as 10BaseT or
100BaseTX. The ports use RJ-45
connectors.
Console Port
The OS6648 front panel provides one RS232
port for console connections. Serial console
connections are used by network administrators
for switch management. This female DB-9 con-
nector provides a DCE console connection.
Stacking or Uplink Module Slot
The OS6648 provides an additional slot that
can accommodate either a stacking module or
a Gigabit Ethernet uplink module.
If you use a Gigabit Ethernet uplink module
in this slot, the OS6648 must be used as a
stand-alone switch.
A stacking module must be installed in this
slot if the switch is to be used in a stack. For
detailed information on stacking switches,
refer to
Chapter 3, “Managing OmniSwitch
6600 Series Stacks.”
Gigabit Ethernet Uplink Module Slot
The OS6648 provides a dedicated slot for Gigabit Ethernet uplink
modules. This slot supports the following module types:
• OS6600-GNI-C2—Provides two fixed 1000BaseT copper
connections (uses two RJ-45 connectors). Supports distances
up to 100 meters.
• OS6600-GNI-U2—Provides two MiniGBIC bays that
support hot-swappable 1000BASE-X MiniGBIC transceivers.
Status and Slot Indicator LEDs
For information on the OS6648’s
status and slot indicator LEDs,
refer to
page 2-11 .
Slot Selector Button
The slot selector button, located
directly beneath the slot indicator
LED, is used to manually assign
slot numbers to switches in stacked
configurations. Refer to
Chapter 3,
“Managing OmniSwitch 6600
Series Stacks,”
for detailed infor-
mation.