Alcatel-Lucent Omni 6624 - Manual (Page 34)

Mounting the Switch OmniSwitch 6600 Series Chassis and Hardware Components
page 2-14 OmniSwitch 6600 Series Hardware Users Guide April 2004
Installation Options
There are two ways in which the OmniSwitch 6600 series switches can be installed:
• Tabletop installation
• Rack-mount installation
Installing the Switch on a Tabletop or Bench
OmniSwitch 6600 series switches can be installed freestanding as tabletop units. Place your switch in a
stable, flat, static-free surface.
Note. OmniSwitch 6600 series switches must be placed “right side up.” Never attempt to operate a switch
positioned on its side.
To install the switch as a tabletop unit, follow the steps below:
1 Position the chassis on the table or bench where it is to be installed.
2 Be sure that adequate clearance has been provided for chassis airflow and access to the front, back, and
sides of the switch. For recommended clearances, refer to page 2-13 . Also, be sure that you have placed
the chassis within reach of all required AC power sources.
3 If you are placing multiple switches in a stacked configuration, carefully stack the remaining switches,
one on top or the other. Up to eight switches may be stacked to form a single virtual chassis. Be sure to
maintain adequate clearance at the front, rear, left, and right side of all switches. Also, be sure that you
have placed all switches in the stack within reach of required AC power sources.
Rack-Mounting the Switch
Refer to the important guidelines below before installing the OmniSwitch chassis in a rack.
• It is recommended that two people install the switch in the rack—one person to hold the chassis and
position it in the rack, and a second person to secure the chassis to the rack using attachment screws
(not supplied).
• Alcatel provides two rack-mount flanges with each OmniSwitch 6600 series switch. These flanges
support standard 19-inch rack mount installations. These flanges must be attached to the chassis before
the switch can be rack mounted.
Note. If you are installing the switch in a 23-inch wide rack, Alcatel offers optional 23-inch rack-mount-
ing hardware. For more information, contact your Alcatel representative.
• Alcatel does not provide rack-mount screws. Use the screws supplied by the rack vendor.
• To prevent a rack from becoming top heavy, it is recommended that you install heavier equipment at
the bottom of the rack whenever possible.
• If you are installing the switch in a relay rack, be sure to install and secure the rack per the rack manu-
facturer’s specifications.
• Review page 2-13 for important chassis airflow and access recommendations before installing.