Mediabridge MHP-EA200X2 User Guide - Manual (Page 31)

Powerline Network Adapter
27
Chapter 5 Using the Pair Button
The device provides 128‐bit AES encryption method. This section presents
how to use the Pair hardware button to create a secure Powerline network.
Note:
Two or more Medialink Powerline adapters under a single electricity meter
will interconnect to create an unencrypted public network automatically
using the same network name of HomePlugAV.
To create an encrypted private connection between 2 Medialink adapters,
do as follows:
1. Press the Pair button on Adapter 1 for 1‐3 seconds and then release it.
The Power LED on the Adapter 1 will start blinking.
2. Within 2 minutes upon releasing adapter 1’s Pair button, press the Pair
button on Adapter 2 for 1‐3 seconds and then release it. The Power LED
on the Adapter 2 will start blinking.
3. Observe the two adapters’ LED status. If the Power and PLC LEDs on the
two adapters deliver solid lights, it indicates an encrypted private
Powerline network is successfully created.