RIKON Power Tools 10-201 - Manual (Page 11)

FENCE ASSEMBLY
1. Fasten the front rail to the table top using four
5/16-18x5/8mm cup hex soc head screws (A)
SEE FIG.17
Fig.17
A
2. Fasten the left rear rail to the table using two
5/16-18x5/8mm hex head screws(B) with M8 flat
Washer and M8 lock washer. SEE FIG.18
Fig.18
B
3. The installation method for right rear rail is the same
As the left one.
C
D
Fig.19
11
4. Connecting the right guide tube(long)and left guide
tube(short)with cap (D), and place them on the front
rail.
5. The guide tube must be fasten by eight M6X16mm
hex soc round head screws(C) with M6 flat washer
and M6 lock washer. SEE FIG.19
Fig.20
7. Place the Fence Body (E) on the table top and
against the blade to make sure that if the "zero"
scale on the cursor (F) is align with the "zero" scale of
the right/left scale label stuck on the guide tube.
8. Loosen the pan head screw (G) and move the cursor
(F) till the zero scale aligns with the zero scale on the
right/left scale. SEE FIG.20
E
F
G
G