RIKON Power Tools 10-201 - Manual (Page 7)

7
• The table saw is a heavy machine; two people may be
required for certain assembly operations.
• DO NOT assemble the table saw until you are sure the
tool is unplugged.
• DO NOT assemble the table saw until you are sure the
power switch is in the "OFF" position.
• For your own safety, DO NOT connect the machine to
the power source until the machine is completely
assembled and you read and understand this entire
User Manual.
INSTALLATION AND LEVELING
Final location for the saw must be level, dry, well lighted,
and have enough room to allow movement around the
saw with long pieces of wood stock.
Level the saw front to back and side to side. If necessary,
but make sure the saw is stable before being placed in to
service.
CABINET LEG ASSEMBLY
Fig. 1
1. Attach leg assemblies (A) to the right (J) and left (k)
of the table saw cabinet by placing (B) eight
M8X16mm carriage screws through the mounting
holes and place an M8 flat washer, M8 lock washer
and M8 hex nut onto each of the eight screws
attaching leg assembly to cabinet. Do not completely
tighten hardware at this time.
2. Attach two tie bars(C) and (H) between right and left
legs inside and tighten them with D) eight
s s
and s.
3. Attach middle bar (E) between tie bar (H) and (C)
inside, using four
( M8X16mm
carriage screws M8 flat washer M8 lock washer
M8 hex nut
M8X16mm carriage screws M8 flat
washers M8 lock washers and M8 hex nuts to tighten
it.
4. To tighten the legs (A) and tie bar (C) by two (L)
M8x45mm hex soc head screws, M8 flat washers, M8
lock washers;
5. Attach Mobile base caster assembly (I) to the tie bar
(H) and using two M8X16mm carriage screws and M8
flange hex nuts to tighten it.
6. Place two leveling screws (G) to the lags (A) and
place an M8 flat washer, M8 lock washer and M8 hex
nut onto each of the two screws and tighten them.
7. Attach two caster wheels(F) to the tie bar(C) and
place two M8x55mm hex soc head screws through the
mounting holes of the bar and wheels, and using M8
lock nut to ighten them.
 


SEE FIG.1
t SEE FIG.1
1. Turn the table saw side lay. The table saw
is heavy; two people are required for this operation. Be
sure to lay cardboard on the floor to protect the table
and cabinet.
CAUTION:
Fig.2
7. To align the hole of cabinet with the hole of cabinet
leg, and using eight M8x20mm hex head screws, M8
flat washers M8 lock washers and M8 hex nuts to
tighten them. 
SEE FIG.2 & FIG.3
I
A B
C
D
E
F
H
G
J
K
L
L